Tailored solutions for industrial flow measurement

Principle of the integrating pitot tube

principle of averaging pitot tube

Integrating pitot tubes are used for the flow measurement of gaseous or liquid fluids such as combustion air, compressed air, natural gas, steam, water etc. in pipes and channels. Pitot tubes have several tappings with and against the direction of flow.

At the tapings against the direction of flow a dynamic positive pressure pdyn1 stagnation pressure develops, at the openings in direction of flow a dynamic negative pressure pdyn2 is developing.

Within the pitot tube the pressures of the tappings are averaged and measured outside of the pitot tube. From the measure dp one can calculate the flowrate in the pipe.

dp = p1 - p2
p1 = pstat + pdyn1
P2 = pstat + pdyn2
dp = pdyn1 - pdyn2


calculation basics of dp measurement

deltaflow avering pitot tubethe basic formula of dp flow measurement is deduced from the law of the conservation of energy. From the dp one can calculate the massflow in the pipe:

qm=K*pi*d^2/4*epsilon*(2*dp*rho)^0.5

qm – mass flow
K – calibration contstant of dp element (K-Number)
d – inside diameter of pipe
epsilon– expansion coefficient
dp – measured differential pressure
rho – density of fluid

The dimensionless calibration constant K is determined by the different manufacturers of averaging pitot tubes and communicated to the user. A typical value is .62 to .68.

The expansion factor epsilon corrects the change in density of the fluid by the pressure loss of the integrating pitot tube. For incompressible fluids (liquids), epsilon = 1, for compressible fluids epsilon is less than 1, but typically remains in the range [0.97 <epsilon <1]. The density rho is the density of the fluid immediately before the integrating pitot tube (rho1).

flow calculation identical with ISO 5167

automotive air mass and egr flow sensorThe calculation basics with pitot tubes is virtually identical, with the calculation basis of the classical primary elements such as orifice, venturi or nozzle. These are described in detail in ISO 5167. The only difference in the formula for calculating the mass flow is the first part of the equation: While the dynamic pressure probe uses here the calibration constant K primary elements are using a fraction in which the diameter ratio beta and the discharge coefficient C are included.

Since the mass flow calculation is -beside the constant part of the equation- identical, pitot tubes can be carried out by most flow computers or computing modules in process control systems. A manual programming is usually not necessary.

 

 

Product Summary

Fluids

  • Gas, Steam
  • Liquids

Pipe Sizes

  • 1..25 mm deltaflow DF8
  • 20..100mm deltaflow DF12
  • 80..2500mm deltaflow DF25
  • 200..15000mm deltaflow DF44

Operating conditions

  • –200 ... 1240 °C
  • 0..690 bar
  • Pure to extremely contaminated, aggressive media
  • Eex ia, ATEX

Certificates

  • ATEX
  • PED 97/23/EC, TRD
  • 2.2 / 3.1 / 3.2 (EN 10204)

Contact form

On these pages you find comprehensive information about how to get in touch with systec Controls and its representations. If you wish to contact us, please use the form below.


Your personal data

Name *

Company

Street *

ZIP Code *

City *

Country *

Phone

E-Mail *

Desired Informations

deltaflow
deltaflow-Pitot
flowcom
deltafit
deltawave
deltawaveC
Accessories

Optional description of a special measurement problem

 Please enter security code. *